Page 1
Replacing the Paper Feed Roller and the Separation Pressure Pad If paper misfeeds or double-feeds are occurring frequently, first try clean- ing the paper feed roller, and then check that you are using the correct feed roller pressure and separation pressure (refer to Operating Instruc- tions).
Page 2
Slide the shaft slightly to the left and lift it out from its right end. ZJSH510E Note ❑ If you are replacing only the separation pressure pad, proceed to Step 9. Take the side roller off the shaft. Remove the snap ring on the pa- per feed roller.
Page 3
Attach the snap ring onto the paper feed roller. Slide the side roller back onto the shaft. To replace the separation pressure pad, first move the separation pressure lever to Position 2. The separation pressure pad protrudes slightly. Lift out the used separation pressure pad. Insert a new pad in its place.
Page 4
Slide in the other end of the shaft. ZJSH550E Note ❑ Check that the pin in the shaft stem fits completely into the slit in the right end of the shaft. Attach the snap ring onto the end of the roller shaft. ZJSH491E Move the separation pressure lever back to Position 3 (the position for Standard paper).