Comtrend Corporation GS-7260 Quick Start Manual

Quick Start Guide

GS-7260| 5-Port Gigabit IGMP Switch
A
Understanding your IGMP Switch
This switch contains LEDs to show the activities and status of the ports, including power LED and Link/ Act LEDs.
Please refer to the front panel of the switch for the positions of the LEDs :
Look at the following table for the description of the LEDs:
LED
Power
Link/ ACT
1-5
Rear Panel
B
Basic Setup
(Note: This switch only supports IGMP v1 & v2)
1. Connect the A/C power adapter to a power outlet, then connect it to the Power Socket of the switch.
The power LED turns on when the switch is receiving power.
2. Connect your xDSL / cable modem to Port 1 of the switch by Ethernet cable.
3. Connect your computers and network devices (Ex. Set-Top-Box, DVR, etc.) to any available port on the switch.
Status
Steady Green
Off
Steady Green
Amber
Blinking
Off
Ethernet Ports
Operation
The switch is powered on
The switch is powered off
1000Mbps connected
10/100Mbps connected
Sending or receiving
Port disconnected or link fail
Power
Socket
Page 1