Programming - Craftsman CMXEOCG781 Owner's Manual

PROGRAMMING

Your garage door opener has been programmed at the factory to operate with your remote control. Older accessories are not compatible. See page 46 for compatible
accessories. Programming can be done through the door control or the learn button on the garage door opener. To program additional remote controls refer to the
instructions provided with the additional remote controls.
IMPORTANT NOTE: If your vehicle is equipped with a Homelink
www.homelink.com for additional information.
PROGRAM A REMOTE USING THE LEARN BUTTON
1. Press and release the Learn button on the
garage door opener. The Learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the button
on the remote control.
3. Release the button when the garage door
opener light blinks. It has learned the code. If
light bulbs are not installed, two clicks will be
heard.
When replacing the light lens cover, ensure the antenna wires are hanging straight
down.
®
, you may require an external adapter depending on the make, model and year of your vehicle. Visit
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/ KEYLESS ENTRY PIN USING
THE LCD DOOR CONTROL
1. Press the navigation button below "MENU"
to view the Features menu.
2. Use the navigation buttons to scroll to
"PROGRAM" and press the navigation button
under
3. Select "REMOTE" or "KEYPAD" to program
from the program menu. Press
continue.
4. Press the button on the remote control that
you wish to operate your garage door.
OR
Enter a 4-digit personal identification
number (PIN) of your choice on the keyless
entry keypad. Then press the ENTER button.
39
to continue.
to
TO R TO REMOTE TO REMOTE
OR
? ? ? ?
PIN