HP 245 G7 Maintenance And Service Manual page 62

5. When replacing the hinge cover, make sure the hinges rotate downward as far as they can go. Align the
cover (1), and then start from above and rotate the cover downward onto the hinges (2). Make sure the
clips snap into place along the bottom of the display cover.
6. If it is necessary to replace the display hinges:
a. Remove the six Phillips M2.5 × 2.5 broadhead screws (1) from the bottom of the hinges.
b. Remove the display hinges (2).
The display hinges are available using spare part number L23194-001.
7. If it is necessary to replace the display panel cable:
a. Release the cable from the retention clips (1) and routing channel built into the bottom edge and
sides of the display enclosure.
54 Chapter 5 Removal and replacement procedures for authorized service provider parts