Flue Exhaust Pipe Connection - Immergas ARES PRO 150 Instructions And Recommendations

Instructions for the installer
3.4 FLUE EXHAUST
PIPE CONNECTION
The flue exhaust pipe must comply with local and national regulations
If the boiler is replaced, ALWAYS replace the flue pipe.
The boiler is approved for the draining settings described below:
• B23P
ATTENTION
For this type of connection, the room follows the
same installation regulations for boilers with natural
draught.
Connection to a combustion product evacuation pipe outside the
room, the combustion air is taken directly from the room where the
device is installed.
Head available at the base of the chimney:
S (Exhaust)
∆p = 100 Pa
The maximum permitted length of the pipes is determined by the head
(∆p) available at the base of the chimney.
ATTENTION:
for the type of B23P connection, the room follows
the same installation regulations for boilers with
natural draught.
A (Intake)
-
22