Removing A Model 744; Tools Required - HP 744 Owner's Manual

Typical Installation in a VME Card Cage
Model 744 Removal
Model 744 Removal

Tools Required

Model 744 removal requires the following tools:
Static grounding wrist strap
Light-duty flat-tipped screwdriver
Preliminary Requirements
Perform the following procedure before you remove the board computer
from the VME card cage:
1 Read the steps in "Turning Off the System," in Chapter 5.

Removing a Model 744

Follow these steps to remove the Model 744 from a VME card cage:
1 Loosen the captive screws at each end of the board computer that hold the
computer in the VME card cage (in Figure 3-3, the screws are labeled 1
and 2 for a single-slot board computer, or 1 through 4 for a dual-slot board
computer).
2 Pull both ejector levers out until the board ejects from the card cage.
3-12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Tool
Preventing static discharge problems
Loosening card cage screws
Used For