Installing The Expansion Adapter Onto The Bridge Adapter - HP 744 Owner's Manual

Installing Accessories
PMC Bridge Adapter and Expansion Adapter
11 Screw the four threaded standoffs into the bridge adapter's VME connec-
tors.
12 Making sure that the connector and bezels are properly aligned, install the
PMC expansion adapter onto the bridge adapter, as shown in Figure 2-9.
Ensure that the interboard connector seats properly by applying pressure
to the top of the expansion board and to the bottom of the bridge board.
You may have to remove memory cards to access the underside of the
bridge board. There are two screws that secure the front bezel, four stand-
offs between the VME connectors, and four screws to secure the VME
connectors.
Expansion Adapter
with 2 PMC Cards Installed
Front Bezel Screws (2)
Figure 2-9

Installing the Expansion Adapter onto the Bridge Adapter

2-18
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Connector Screws (4)
Interboard
Connector
Standoffs (4)
Bridge Adapter