Do not operate power tools unless you read and of this Elkay Manufacturing Company (Elkay) product. understand the instructions and warnings in this Additional use and care documents can be found on the and all other applicable manuals.
Email: installservice@elkay.com Website: http://www.elkay.com/contact-us/install 1.8 Warranty This product is covered by a Limited Warranty and Elkay 1.5 Disclaimer will not be held responsible for damage of any kind The information contained in this manual is given free of in connection with the installation of the product.
Also, make sure no one else specifically recommended by Elkay is used, you must be can be injured by flying particles when using satisfied that it is safe for yourself and others. You should power tools.
40 and 105 psi. The water dispenser with the product before starting the installation. filter requires 40 psi minimum water pressure. The optimum water pressure is 60 psi. (630) 574-8484 Elkay Manufacturing Company Installation Manual (1000005449 Rev. A) In-Wall Filtered Water Dispenser...
Follow all safety CAUTION practices and industry regulations and standards when connecting any electrical device. A minimum 15 AMP GFCI Circuit Breaker is required for safe installation. (630) 574-8484 Elkay Manufacturing Company Installation Manual (1000005449 Rev. A) In-Wall Filtered Water Dispenser...
Note: Do not completely tighten the screws until the filter unit cover is installed and the fit between the water dispenser cover and the filter cover is checked. Elkay Manufacturing Company (630) 574-8484 In-Wall Filtered Water Dispenser Installation Manual (1000005449 Rev. A)
3/32 Allen wrench. 8. Connect the 1/4" tube to the fitting below the filter, as shown. (630) 574-8484 Elkay Manufacturing Company Installation Manual (1000005449 Rev. A) In-Wall Filtered Water Dispenser...
Remove the NFC card. c. Remove the four screws that hold the bracket to the filter head. Note: Elkay also recommends installing a shutoff valve at the source of the water supply for the water dispenser. 10. Attach the filter cartridge by firmly inserting it onto the filter head and twisting it clockwise until it is completely seated.
8. Place the filter into filter head with the label facing Chiller outward. 9. Firmly press the filter into the filter head and turn it clockwise (install). (630) 574-8484 Elkay Manufacturing Company Installation Manual (1000005449 Rev. A) In-Wall Filtered Water Dispenser...
If it fits well, place a small amount of plumbers putty around the lip of the strainer flange and insert it into the hole. Elkay Manufacturing Company (630) 574-8484 In-Wall Filtered Water Dispenser Installation Manual (1000005449 Rev. A)
Attach the other end to the p-trap drain adapter using a hose clamp. The drain adapter is designed to be glued into a 1-1/4" PVC pipe. (630) 574-8484 Elkay Manufacturing Company Installation Manual (1000005449 Rev. A) In-Wall Filtered Water Dispenser...
10. Once the installation is complete, the water has been turned on, and any trapped air has been bled from the system re-check for any water leaks. Elkay Manufacturing Company (630) 574-8484 In-Wall Filtered Water Dispenser Installation Manual (1000005449 Rev. A)