Solid-State Drive - HP 14-dk0 Series Maintenance And Service Manual

Solid-state drive

Table 5-8 Solid-state drive descriptions and part numbers
Description
Solid-state drive, PCIe:
512 GB, value
●
512 GB, TLC
●
256 GB
●
Solid-state drive, SATA-3, TLC:
● 256 GB
● 128 GB
Solid-state drive bracket
Solid-state drive board
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to install the solid-state drive.
Computer feet on page
Bottom cover on page
Battery on page
Solid-state drives are designed with notches to prevent incorrect insertion.
(Preparation for disassembly on page
31).
33).
35).
Spare part number
L53824-001
L56925-001
L53823-001
L53822-001
L53821-001
L24488-001
L24487-001
31).
Component replacement procedures 43