Battery connector (fanless products only)
Table 5-12
Battery connector description and part number
Description
Battery connector
Before removing the battery connector, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the heat plate (see
Remove the battery connector:
1.
Disconnect the battery connector cable from the system board (1).
2.
Remove the two Phillips M2.0 × 3.0 screws (2) that secure the connector to the computer.
3.
Lift the battery connector out of the computer (3).
Reverse this procedure to install the battery connector.
44
Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page
29).
Heat sink (thermal module) on page
26).
27).
41).
Spare part number
L64889-001