Handling And Safety Instructions; Safety Symbols Information; Important Inverter Safety Instructions - SolarEdge SE66.6KUS Installation Manual

HANDLING AND SAFETY INSTRUCTIONS

During installation, testing and inspection, adherence to all the handling and safety instructions is
mandatory. Failure to do so may result in injury or loss of life and damage to the equipment.

Safety Symbols Information

The following safety symbols are used in this document. Familiarize yourself with the symbols and their
meaning before installing or operating the system.
WARNING!
Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could
result in injury or loss of life. Do not proceed beyond a warning note until the indicated conditions
are fully understood and met.
AVERTISSEMENT!
Dénote un risque: il attire l'attention sur une opération qui, si elle n'est pas faite ou suivi correctement,
pourrait causer des blessures ou un danger de mort. Ne pas dépasser une telle note avant que les
conditions requises soient totallement comprises et accomplies.
CAUTION!
Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could
result in damage or destruction of the product. Do not proceed beyond a caution sign until the
indicated conditions are fully understood and met.
ATTENTION
Dénote un risque: il attire l'attention sur une opération qui, si elle n'est pas faite ou suivi correctement,
pourrait causer un dommage ou destruction de l'équipement. Ne pas dépasser une telle note avant que
les conditions requises soient totallement comprises et accomplies.
NOTE
Denotes additional information about the current subject.
IMPORTANT SAFETY FEATURE
Denotes information about safety issues.
IMPORTANT INVERTER SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING!
The inverter cover must be opened only after shutting off the inverter ON/OFF switch located at the
bottom of the Primary Unit, above the Connection Unit. This disables the DC voltage inside the inverter
and opens the AC relays. Wait five minutes before opening the cover. Otherwise, there is a risk of
electric shock from energy stored in the capacitors.
AVERTISSEMENT!
Ne pas ouvrir le couvercle de l'onduleur avant d'avoir coupé l'interrupteur situé en dessous de l'onduleur.
Cela supprime les tensions CC et CA de l'onduleur. Attendre que le LCD affiche une tension sécurisée
(50V). Si l'affichage LCD n'est pas visible, attendre cinq minutes avant d'ouvrir le couvercle. Sinon, il y a
un risque de choc électrique provenant de l'énergie stockée dans le condensateur.
-Three Phase Inverter with Synergy Technology Installation MAN-01-00402-1.4
HANDLING AND SAFETY INSTRUCTIONS
7