M12 Connector For Connecting The Sia Module 6Dr4004-6G /-8G (-Z D56); M12 Connector For Connecting The Mechanical Limit Switch Module 6Dr4004-6K (-Z D57); Pneumatic Connection; Basic Safety Instructions For The Pneumatic Connection - Siemens SIPART PS2 Operating Instructions Manual

Connect

5.3 Pneumatic connection

5.2.4.5

M12 connector for connecting the SIA module 6DR4004-6G /-8G (-Z D56)

You have a positioner with order suffix -Z order code D56. In this version of the positioner, the
M12 connector is used to electrically connect the outputs of the SIA module.
Table 5-5
Alarm output terminal
41 (+)
52 (-)
42 (-)
51 (+)
5.2.4.6

M12 connector for connecting the mechanical limit switch module 6DR4004-6K (-Z D57)

You have a positioner with order suffix -Z order code D57. In this version of the positioner, the
M12 connector is used to electrically connect the outputs of the mechanical limit switch module.
Table 5-6
Alarm output terminal
41 (+)
52 (-)
42 (-)
51 (+)
5.3 Pneumatic connection
5.3.1

Basic safety instructions for the pneumatic connection

Pneumatic auxiliary power
For safety reasons, the pneumatic auxiliary power supply can be fed after installation only if
the positioner is switched to "P-Manual mode" when an electrical signal is present. This
operating mode is preset in the delivery state.
Note
Specifications regarding air quality
Observe the specifications regarding the air quality, see section "Technical specifications
> Pneumatic data (Page 282)".
92
Assignment diagram
Assignment diagram
WARNING
Pole designation
1 - Brown
4 - Black
3 - Blue
2 - White
Pole designation
1 - Brown
4 - Black
3 - Blue
2 - White
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC