Siemens SIPART PS2 Operating Instructions Manual page 75

● Any already installed optional module has been removed.
● You have one of the following external position detection systems / Position Transmitters:
– 6DR4004-.N* NCS sensor
– C73451-A430-D78 Polycarbonate enclosure with potentiometer
– 6DR4004-1ES Aluminum enclosure with potentiometer
– 6DR4004-2ES Aluminum enclosure with NCS
– 6DR4004-3ES Aluminum enclosure with NCS and SIA module / Inductive Limit Switch
– 6DR4004-4ES Aluminum enclosure with NCS and Mechanic Limit Switch (MLS)
Procedure for installing the EMC filter module
①
②
③
④
Figure 4-21
1. Open the positioner as described in section "Opening the standard and and intrinsically safe
version (Page 53)".
2. Remove the ribbon cable from the basic electronics.
3. Loosen the two fixing screws of the basic electronics
4. Remove the basic electronics.
5. Loosen the screw
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
(ILS)
EMC filter module terminals
Yellow wheel for locking the position detection
Positioner
Ribbon cable connector of fitted potentiometer,
or ribbon cable connector of EMC filter module
Installation EMC filter module
⑥
in the connection area of the positioner.
4.5 Installing the optional modules
⑤
Basic electronics
⑥
Screw
⑦
EMC filter module 6DR4004-6F/-8F
⑤
.
Installing/mounting
75