Siemens SIPART PS2 Operating Instructions Manual page 69

3. Move the actuator to the second desired mechanical position.
4. Adjust the lower actuating disk
changes. Set a high-low or a low-high switchover as follows:
– Rotate the actuating disc beyond the switching point until you reach the next switching
See also
Mechanical limit switch modules 6DR4004-6K and -8K (Page 66)
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
point.
Note
Adjusting the actuating disk
④
The actuating disks
unintentional movement during operation. You can achieve an easier and finer
adjustment by reducing stiction temporarily.
● Move the actuator to and fro while simultaneously holding the actuating disks
⑤
and .
⑤
manually until the output signal at terminals 41 and 42
⑤
and are relatively difficult to move. This design prevents their
Installing/mounting
4.5 Installing the optional modules
④
69