Siemens SIPART PS2 Operating Instructions Manual page 49

4. Place the positioner and the mount on the actuator carefully. One of the two pins
coupling wheel
Figure 4-9
5. When using the stainless steel coupling (article number TGX: 16300-1556): Place the
positioner and the mount on the actuator carefully. Place the stainless steel coupling on the
stump of the actuator's positioner shaft.
6. Align the positioner with mount at the center of the actuator.
7. Fasten the positioner with mount.
8. Initialize the positioner.
9. After commissioning, drive the positioner to the end position.
10.Stick the scale
The stickers with scale are self-adhesive.
Figure 4-10
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
①
must fit in the carrier
Left: Orientation of mount; right: Orientation of mount, flameproof enclosure
④
with the direction of rotation or the swivel range on the coupling wheel
Left: Adhesive label with scale; right: Adhesive label with scale, flameproof enclosure
4.3 Mounting to part-turn actuator
②
when you do this.
Installing/mounting
⑫
of the
①
.
49