Siemens SIPART PS2 Operating Instructions Manual page 353

1. Mount the positioner without basic electronics 6DR5910-... to the valve. Mounting
corresponds to the mounting of the positioner in non-flameproof enclosure.
Installing/mounting (Page 39)
2. Connect the positioner with the 19" slide-in module.
Connecting the positioner to the 19" slide-in module (Page 354)
3. Note the grounding concept of the 19" slide-in module (Page 361).
4. Loosen the three mounting screws
5. Assign the channels via the coding bridges
PA cable connection for bus connection (Page 357)
6. Plug the male connector Burndy B50 into the corresponding socket on the QRL module.
Connecting the positioner to the 19" slide-in module (Page 354)
7. Connect the PA cable that you want to use to connect the 19" slide-in module to the control
room.
PA cable connection for bus connection (Page 357)
8. Initialize the positioner using the three buttons of the associated channel of the PA module.
Example: Channel CH1 of PA module 1
for all additional positioners until all channels are ready to use.
Note the technical specifications of the 19" slide-in module (Page 359) and the technical
specifications of the positioner (Page 281).
Note the general safety instructions (Page 19) as well as the basic safety instructions in section:
● Installing/mounting (Page 39)
● Connect (Page 77)
● Commissioning (Page 107)
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
Positioner with remote control electronics
⑥
and remove the cover.
⑦
.
⑧
for the first positioner. Repeat the initialization
F.2 19" slide-in module
353