Siemens SIPART PS2 Operating Instructions Manual page 344

Booster
E.5 Booster mounting, flameproof enclosure
3. Apply light pressure to the lock washers
4. Fasten the connection block
5. Fasten the connection block
washers
6. Check whether the O-rings are in the manometer block. There are two O-rings in the single-
acting version. There are three O-rings with the double-acting version.
7. Apply light pressure to the lock washers
C. Tighten screws
Tighten the screws in the following sequence:
1. Screws
2. Screws
3. Screws
4. Mount the positioner on the actuator as described in:
– Mounting to linear actuator (Page 42)
– Mounting to part-turn actuator (Page 47)
5. Use the existing interfaces on the booster.
344
⑨
⑨
⑪
.
⑦
which are used to fasten the manometer
⑫
which are used to fasten the connection block
⑩
which are used to fasten the connection block
⑧
. The screws are tightened later.
to the booster with 2 screws
to the manometer block
⑬
. The screws are tightened later.
⑥
Operating Instructions, 05/2019, A5E00127926-AC
⑫
and 2 lock washers
⑥ ⑩
with 2 screws and 2 lock
to the positioner.
⑨
to the booster.
⑨
to the manometer
SIPART PS2 with PROFIBUS PA
⑬
.
⑥
.