Mounting Booster, Without Flameproof Enclosure - Siemens SIPART PS2 Operating Instructions Manual

E.4

Mounting booster, without flameproof enclosure

Requirements
1. You are familiar with the safety instructions in section "Installing and mounting".
2. You have one of the following boosters:
– With single-acting positioners, booster with the article number 6DR4004-1RJ or -1RK
– With double-acting positioners booster with the article number 6DR4004-2RJ or -2RK
A. Mount extension shaft and booster
Using the example of a single-acting positioner
1. Remove the extension shaft
2. Lower the extension shaft
3. Tighten the locking screw
4. Check that the extension shaft
5. Screw the 4 threaded bolts
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
E.4 Mounting booster, without flameproof enclosure
①
from the booster mounting kit.
①
completely into the positioner.
②
at the flat end of the positioner shaft.
①
sits properly.
③
with the short end of the thread into the positioner.
Booster
337