Mounting On Linear Actuator Up To 14 Mm (0.55 Inch) - Siemens SIPART PS2 Operating Instructions Manual

External position detection
B.2 Non-Contacting Sensor
B.2.2.2

Mounting on linear actuator up to 14 mm (0.55 inch)

Requirement
1. An EMC filter module in the positioner.
2. An NCS for linear actuators up to 14 mm (0.55 inch) 6DR4004-.N.20.
3. A linear actuator with interface to NAMUR. This installation must be carried out individually.
Only a NAMUR mounting bracket can be used as mounting base. The following figure
shows the assembly with NAMUR mounting bracket. Or:
A linear actuator without interface to NAMUR and individual mounting solution.
You can find the dimensions of the NCS as well as the NCS magnet under Dimensional drawing
of non-contacting sensor (Page 323).
314
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC