Siemens SIPART PS2 Operating Instructions Manual page 128

Commissioning
7.7 Commissioning part-turn actuators
Initializing the positioner manually
1. Switch to the "Configuration" mode. To do this, press the
until the display shows the following:
2. Set the "YFCT" parameter to "turn". To do this, press
3. Call the second parameter "YAGL". To do this, press
4. Call the "INITM" parameter. To do this, press the
following:
5. Start the initialization process. Press the
shows the following:
6. The current potentiometer position is output on the display after 5 seconds:
7. Determine the lower endstop of the actuator.
8. Move the actuator to the desired position using the
128
button for at least 5 seconds
. The display shows the following:
. The display shows the following:
button twice. The display shows the
button for at least 5 seconds until the display
or button.
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC