Automatic Initialization Of Linear Actuators - Siemens SIPART PS2 Operating Instructions Manual

Commissioning
7.6 Commissioning linear actuators
7.6.2

Automatic initialization of linear actuators

Conditions
The following conditions must be fulfilled before activating the automatic initialization:
1. The actuator spindle can be moved completely.
2. The actuator spindle is at a central position after moving.
Initializing the linear actuator automatically
Note
Interrupting initialization
An ongoing initialization can be interrupted at any time. To do this, press
configured until then are retained.
All parameters are reset to factory settings only if you have explicitly activated the preset
settings in the "PRST" parameter.
1. Switch to the "Configuration" mode. To do this, keep the
seconds. The display shows the following:
2. Call the "2.YAGL" parameter. To do this, press
depending on the setting:
3. Check whether the value displayed in the "2.YAGL" parameter matches the setting of the
transmission ratio selector. If required, change the setting of the transmission ratio selector
to 33° or 90°.
120
button pressed for at least 5
. The following is shown on the display
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC
. The settings