Overview Of Configuration; Description Of Operating Modes - Siemens SIPART PS2 Operating Instructions Manual

Operation
6.2 Operating modes
6.2.3

Overview of configuration

The following picture illustrates the handling of operating modes such as "Configuration" and
"Initialization mode":
Figure 6-4
6.2.4

Description of operating modes

P manual mode
Note
Delivery state
The "P manual mode" is preset for the positioner in the delivery state.
The display of the positioner shows the current potentiometer position in the upper line. "NOINI"
blinks in the second line of the display.
Move to the actuator with the
Switch to "Configuration" mode to adapt the actuator to the positioner.
Alarms or position feedbacks can be triggered after initializing the positioner completely.
Configuration and initialization
To get to the "Configuration" mode, press the
You can use the "Configuration" mode to adjust the positioner individually as per your actuator
and start commissioning or initialization.
102
Overview of the "Configuration" operating mode
or buttons.
button for at least 5 seconds.
Operating Instructions, 05/2019, A5E00127926-AC
SIPART PS2 with PROFIBUS PA