Advertisement
Quick Links
Installation
Instructions
"If you have questions, call 800.GE.CARES or visit our website at: GEAppliances.com"
PARTS INCLUDED
Island Trim
TOOLS YOU WILL NEED
Nutdriver
Cut Resistant Gloves
31-10953 02-14 GE
Gas Slide-in Range
Island Installation Kit
(3) ¼" drive #8 x 3/4"
Sheet Metal Screws
T10 TORX
Bit
®
Safety Glasses
In order to install the island trim kit, you must first
remove the two (2) short trim pieces on both sides.
Side Trim
T10 TORX
Screws
®
1. Remove (3) three T10 TORX
2. Remove (1) one ¼" sheet metal screw retaining
the rear trim and discard.
NOTE: When the screws are removed from the
rear trim it may flex away from the back of the
range – this is normal.
3. Remove short trim.
4. Repeat steps 1 thru 3 on the opposite corner.
1
Rear Trim
Short Trim
Sheet Metal
Screw
screws.
®
Advertisement
Related Manuals for GE JXS81WW
Summary of Contents for GE JXS81WW
- Page 1 Gas Slide-in Range Instructions Island Installation Kit “If you have questions, call 800.GE.CARES or visit our website at: GEAppliances.com” PARTS INCLUDED In order to install the island trim kit, you must first remove the two (2) short trim pieces on both sides.
-
Page 2: Installation Instructions
Installation Instructions 5. Install island trim piece making sure that the 7. Install (2) two T10 TORX screws into the side trim. ® side lap joint engages with the side trim on both sides. NOTE: Make sure that the notch on island trim fits into the slot of the rear trim.