Wlan Module - HP Chromebook x360 14 Maintenance And Service Manual

WLAN module

Description
Intel Dual Band Wireless-AC 7265 802.11 ac 2×2 WiFi + Bluetooth 4.2 Combo Adapter
NOTE: WLAN module Mylar and tape are included in the Miscellaneous Parts Kit, spare part number
L36912-001.
CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Disconnect the battery (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
2. Remove the Phillips M2.0×3.0 screw (2) that secures the WLAN module to the system board. (The WLAN
module tilts up.)
3. Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
NOTE: If the WLAN antenna is not connected to the terminal on the WLAN module, a protective sleeve must
be installed on each antenna connector, as shown in the following illustration.
Computer feet and bottom cover on page
Battery on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1."
WLAN modules are notched to prevent incorrect installation.
(Preparation for disassembly on page
20).
Spare part number
901229-855
18).
18).
Component replacement procedures 21