Health O Meter 1100KL User Instructions page 8

ASSEMBLY INSTRUCTIONS (CONT.)
5. Align the left and right side handrails
with the mounting holes in the center
handrail. Insert the four M10 1.5 x
40mm bolts (Part A) through the side
handrails into the mounting holes in the
center handrail. Lightly tighten using the
8mm Allen wrench.
6. Facing the scale, pull the side handrails
toward you to tip the scale and gently
place it face down on the floor. Thread
the four feet into the underside of the
platform. Each foot should be completely
hand tightened then back the feet out 1-
½ full turns. This allows for proper load
cell operation.
7. Carefully tilt the scale back to an upright
position on the floor. Warning: Do not
drop scale, as this can permanently
damage the load cells. Adjust the feet
to level the scale. Be certain that the feet
are not completely tightened into the
platform. Pull the excess cable through
the top of the center handrail.
8. Obtain the display head and align the
four holes on the back of the display
head with the four mounting holes on
the silver display support. Using the four
included M4 0.7 x 10mm screws (Part
C), fasten the display head onto the
display support using a Phillips head
screwdriver to tighten the screws.
P/N UM1100KL_1100KG_REV20181128
Ensure that the
spacer spring is on
the bolt of the foot
before inserting into
the platform.
8