Health O Meter 1100KL User Instructions page 7

ASSEMBLY INSTRUCTIONS (CONT.)
®
Health o meter
two people.
Warning: Do not drop scale, as this can permanently damage the load cells.
Caution: Do not insert the batteries into the display head until it is mounted onto
the scale.
1. Remove the scale platform/base from
the carton and place on a flat, level, and
dry surface with the Health o meter
Professional logo facing you. Locate the
center handrail and the load cell cable
protruding from the bottom of the right
side. Feed the load cell cable into the
handrail support on the right side of the
scale platform. Feed the cable through
the support and out through the hole
behind the wheel on the underside of
the platform. Ensure that the cable is fed
through the hole towards the top of the
wheel, not through the channel next to
wheel.
2. Grasp the load cell cable protruding from
the bottom of the platform and feed it
through the protective metal shield.
3. Plug the load cell cable into the load cell
port located on the bottom of the
platform.
4. Position the center handrail onto the left
and right handrail supports on the scale
platform. Be sure not to pinch the cable.
Place the four M8 washers (Part E) onto
the four M8 1.25 x 20mm bolts (Part B)
and insert into the mounting holes on the
handrails and into the handrail support.
Lightly tighten using the included 5mm
Allen wrench. Do not over-tighten.
P/N UM1100KL_1100KG_REV20181128
Professional Scales recommends that assembly be performed by
7