Health O Meter 1100KL User Instructions page 19

OPERATING INSTRUCTIONS (CONT)
Weighing a Patient and Taring a Known Weight / Pre-Tare
Pre-Tare can be performed within the following weight limits: 0.2 lb - 200 lb / 0.1 kg – 91 kg)
1. Wait until "0.0" appears on the display.
2. Press and hold
will change and prompt entry of the weight value to be tared.
Use the arrow keys to enter the weight to be tared. Press
to save the tare value.
3. The scale will zero and the tare value will show as a negative
weight on the display. The word "TARE" will also appear at the
bottom center of the display along with the tare value.
4. Place the patient on the scale. The scale will automatically
deduct the tare value from the weight of the patient. The
display will show the patient's weight.
5. The weight may be held on the display by pressing
The scale will continue to display the patient's weight after
they step off the scale and will remain on the display until
released or the scale is powered off. To release, press
6. To reweigh the patient without removing them from the scale,
press .
Reweigh
7. To see the patient's weight in another unit of measurement,
press and hold down
convert the weight to KG. If the scale is in KG mode, it will
convert the weight to LB. Note: This function is not available
on KG models or on KL models with Everlock
with the "Unit View" setting disabled.
8. To remove the Tare, press
disappear from the bottom of the display, and the tare value
will be cleared from the display. The scale will resume normal
operation.
P/N UM1100KL_1100KG_REV20181128
Tare
for approximately 3 seconds. The display
Unit . . If the scale is in LB mode, it will
Tare
. The word "TARE" will
Enter
Hold/
Release
.
.
Hold/
Release
®
engaged or
19