Parts List; Roof Installation - Winegard ConnecT WF1xT Series Installation & Operation Manual

PARTS LIST

Outdoor Unit (ODU) w/ Outdoor 2.4ghz
Impact Pad Antennas (3)
Mounting Feet
with Nuts (3)
WARNINGS:
• Read this manual carefully and completely before attempting to assemble,
install or operate this product. Winegard recommends the installation of
this equipment be done by a professional technician familiar with the
vehicle in which it is installed.
• Winegard recommends wiring directly to a fused panel or fused box.
However, if you are wiring to the battery, understand that batteries may
expel explosive gases when not properly ventilated, therefore, special
care and consideration is required. Consult your vehicle manufacturer for
additional information on safely installing accessories.
• Save these instructions.
• Do not mount closer than 12 inches from the edge of the roof or any adjacent
devices.
• Do not paint any portion of the Winegard
could damage the system and will void the warranty.
• When first setting up the Winegard ConnecT it is recommended to check for
software updates the first time the system is connected to an internet signal.
It is also recommended to check for updates every couple months for fixes
and added features.
• Winegard 4G LTE service will not work in Mexico.
• At the time this manual is written, ConnecT products will work with the
Winegard Data Plan, AT&T
receive the correct SIM card and information on data plans (Mini/Standard
SIM).
*Visit www.winegard.com/connect to see the updated approved cellular providers.

ROOF INSTALLATION

Remove each antenna from the protective bag and screw it into the correct
1)
open port on the outdoor unit (ODU). Figure 1.
Firmly tighten each antenna by hand. If using a wrench, do not overtighten
2)
the antenna as the antennas or housing may become damaged. The
antennas should be tightened to 20–25 inch pounds of torque.
Attach the mounting feet to the unit by threading the provided nuts to the
3)
post on the mounting feet. Tighten nuts using an 11/32" wrench. Figure 1.
1
4G LTE ONLY
Outdoor 4G LTE
Antennas (2)
® ConnecT ™ . Painting the system
and Verizon Wireless*. Consult your carrier to
® ®
(Additional Mounts Sold Separately)
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
Outdoor Unit Cable Cable Entry
Entry Cover w/Screw
Mounting
9.5" Power Cable
Screws (20)
NOTE:
http://www.winegard.com/myantenna.
We will be able to pass along relevant
information, as well as, inform you
when software updates are available.
Maintenance:
Periodically check the ODU to
ensure all connections are tight.
As with all electronics, cycle power
every few days to keep things
running smoothly.
10' Ethernet Cable
Plate
Power Inserter (PoE)
Please register your product at
Figure 1
WiFi 4G LTE
Antennas
Antenna secured Foot attached
to ODU to ODU