Step 2: Commissioning And Configuring The Installation - SolarEdge SE5K Installation Manual

36 Step 2: Commissioning and Configuring the Installation
3. When the activation is complete, do one of the following:
Select Activate Another Inverter to continue activating additional inverters
Select Start Commissioning for pairing and other system configuration. The
Commissioning screen is displayed. Refer to the next section for more
information.
Step 2: Commissioning and Configuring the
Installation
This section describes how to use the SetApp menus for commissioning and
configuring the inverter settings.
Menus may vary in your application depending on your system type.
To access the Commissioning screen:
Do one of the following:
During first time installation: Upon Activation completion, in the SetApp, tap
Start Commissioning. The main Commissioning menu screen is displayed.
If the inverter has already been activated and commissioned:
If not already ON - turn ON AC to the inverter by turning ON the circuit
breaker on the main distribution panel.
Open SetApp and follow the instructions on the screen (scan the inverter
bar-code; move the ON/OFF/P switch to P position (for less than 5 sec) and
release).
The mobile device creates a Wi-Fi connection with the inverter and displays
the main Commissioning screen.
In the main menus, tap the menu red arrows (
or configuration task. Tap the Back arrow (
The next sections provide more information about configuration options (in addition to
Country and Language and Pairing, described in Step 2: Commissioning and
Configuring the Installation on page 36).
Setting Country and Language
1. From the Commissioning screen select Country and Language .
2. From the Country drop-down list, select the required country setting.
›
) to perform the system commissioning
) to return to the previous menu.
‹
-Three Phase System Installation Guide MAN-01-00505-1.2