Resetting filter cleaning alarm
When the
appears on the remote controller, clean the filter and set the filter reset off in the user setting mode .
• You can see how to access user setting mode at the page 18~19 .
NOTE
On-timer
When an indoor unit is turned off,
Press the [ Timer ] button .
- Time segment will blink in 1 second period in setting mode .
- Press [ + ]/[ - ] button to adjust the time .
- Time is set by 30 minutes unit for less than 3 hours, and by 1 hour unit for more than 3 hours .
- Time can be set from 30 minutes to 24 hours maximum .
1 . Press the [ OK ] button when time setting is completed . Time segment will stop blinking and remaining time
will decrease by 1 minute unit from set time .
- If there is no input during 3 minutes in setting mode, set time and the mode will be canceled .
2 . Press and hold [ Cancel ] button for more than 3 seconds to cancel the setting mode without saving the
current setting .
3 . Press and hold [ Cancel ] button for more than 3 seconds to cancel the on timer after setting is finished .
• On timer function can be set only when an indoor unit is turned off .
NOTE
MWR-SH11N_IB_EN_DB68-08072A-00.indd 14
User Setting
Mode
ENGLISH-14
2018/10/16 19:41:47