Revision Lists Version Section Details Initial release of this document. 1.00 Created this manual for D146 series. Revised all sections according to the 1.10 release of D197 series Changed some parts name. Read This First > Safety and Symbols Revised some icons. Replacement and Adjustment >...
Safety and Symbols This manual uses several symbols and abbreviations. The meaning of those symbols and abbreviations are as follows: Clip ring Screw Connector Clamp Short Edge Feed Long Edge Feed [A] Short Edge Feed (SEF) [B] Long Edge Feed (LEF) Trademarks ®...
The Aim of Anti-tip Components and Precautions The anti-tip components are necessary for meeting the requirements of IEC60950-1, the international standard for safety. The aim of these components is to prevent the products, which are heavy in weight, from toppling as a result of people running into or leaning onto the products, which can lead to serious accidents such as persons becoming trapped under the product.
TABLE OF CONTENTS Revision Lists................................1 Safety and Symbols............................2 Trademarks..............................2 The Aim of Anti-tip Components and Precautions..................3 1. Replacement and Adjustment Rear Cover................................5 Tray Lift Motor..............................7 Transport Motor..............................8 Paper Feed Motor..............................9 Controller Board...............................10 Transport Sensor, Limit Sensor, Paper End Sensor, Paper Feed Sensor............11 Paper Feed Unit..............................14 Pick-up Roller, Feed Roller, Friction Roller.....................17...
Transport Sensor, Limit Sensor, Paper End Sensor, Paper Feed Sensor Transport Sensor, Limit Sensor, Paper End Sensor, Paper Feed Sensor Paper feed unit (page 14). Transport sensor bracket [A] ( ×1, ×1). Transport sensor [A].
Page 14
1. Replacement and Adjustment Paper feed sensor bracket [A] ( ×1, ×1). Paper feed sensor [A]. Paper end sensor [A] ( ×1).
Page 15
Transport Sensor, Limit Sensor, Paper End Sensor, Paper Feed Sensor Limit sensor [A] ( ×1).
1. Replacement and Adjustment Paper Feed Unit Pull out the paper tray. Rear cover (page Right lower cover [A] (hook ×1). Right rear cover [A] ( ×1).
Page 17
Paper Feed Unit Open the transport cover [A]. Transport guide [A] (tab ×1). Harness guide [A] ( ×2).
Page 18
1. Replacement and Adjustment Release the clamp, and then disconnect the harness at the right rear of the unit ( ×1, ×1). Release the four clamps ( ×4). Paper feed unit [A] ( ×2).