Safety and Symbols This manual uses several symbols and abbreviations. The meaning of those symbols and abbreviations are as follows: Clip ring Screw Connector Clamp Short Edge Feed Long Edge Feed [A] Short Edge Feed (SEF) [B] Long Edge Feed (LEF) Trademarks ®...
The Aim of Anti-tip Components and Precautions The anti-tip components are necessary for meeting the requirements of IEC60950-1, the international standard for safety. The aim of these components is to prevent the products, which are heavy in weight, from toppling as a result of people running into or leaning onto the products, which can lead to serious accidents such as persons becoming trapped under the product.
TABLE OF CONTENTS Safety and Symbols............................1 Trademarks..............................1 The Aim of Anti-tip Components and Precautions..................2 1. Replacement and Adjustment Rear Cover................................5 Right Tray, Left Tray............................6 Left Tray Paper Sensor............................8 Transfer Home Position Sensor..........................9 Controller Board...............................11 Paper Feed Unit..............................12 Lower Limit Sensor............................14 Tray Set Switch (Left)............................15 Tray Set Switch (Right).............................16 Tray Lift-Transport Unit.............................17...
Transfer Home Position Sensor Transfer Home Position Sensor Pull out the paper tray. Left cover [A] ( ×1) Transfer home position sensor unit [A] ( ×1, ×1, ×2)
Page 12
1. Replacement and Adjustment Transfer home position sensor [A]...
1. Replacement and Adjustment Transport Sensor, Paper Fed Sensor, Paper End Sensor, Limit Sensor Paper feed unit ( page Transport sensor unit [A] ( ×1, ×1) Transport sensor [A]...
Page 29
Transport Sensor, Paper Fed Sensor, Paper End Sensor, Limit Sensor Paper feed sensor unit [A] ( ×1) Paper feed sensor [A]...
Page 30
1. Replacement and Adjustment Press the claw shown by the blue circle, and remove the paper end sensor [A] ( ×1) Limit sensor [A] ( ×1)
Side Fence Side Fence Pull out the left tray and right tray. Right tray side fence (front), [A], right tray side fence (rear) [B] and right tray end fence [C] ( ×3)