Sp2-Xxx (Drum) - Ricoh Aficio MP 1600L2 Field Service Manual

[0 = Disabled / 1= Enabled
The program dedicated to envelope printing runs when you enable this program (SP 1911
1911 1
1) and you select "Thick Paper" as the paper type of the by-pass tray (System Settings >
Tray Paper Settings > Paper Type: Bypass Tray).

SP2-XXX (Drum)

2001* Charge Roller Bias Adjustment
Printing
Adjusts the voltage applied to the charge roller when printing. The actually applied voltage
2001 1
changes automatically as charge roller voltage correction is carried out. The value you set
here becomes the base value on which this correction is carried out.
ID sensor pattern
Adjusts the voltage applied to the charge roller when generating the Vsdp ID sensor pattern
2001 2
(as part of charge roller voltage correction). The actual charge-roller voltage is obtained
by adding this value to the value of SP 2001 1.
2101* Erase Margin Adjustment
Leading edge
2101 1
Adjusts the leading edge erase margin.
Trailing
2101 2
Adjusts the trailing edge erase margin. The rear trailing edge is this value plus 1.2 mm.
Left side
2101 3
Adjusts the left edge erase margin. The rear left edge is this value plus 0.3 mm.
[–2100 to –1500 / –1700 / 1 V/step]
[0 to 400 / 300 / 1 V/step]
[0.0 to 9.0 / 2.0 / 0.1 mm/step] (
Printing/Scanning)
Specification: 2 ± 1.5 mm
[0.0 to 9.0 / 3.0 / 0.1 mm/step] (
Printing/Scanning)
Specification: 2 +2.5/–1.5 mm
[0.0 to 9.0 / 2.0 / 0.1 mm/step] (
Printing/Scanning)
Specification: 2 ± 1.5 mm
SP Mode Tables
Copy Adjustments
Copy Adjustments
Copy Adjustments
3
25