Input Check (Sp 5803) - Ricoh Aficio MP 1600L2 Field Service Manual

6. When the program has ended normally, the message "Completed" is displayed. If the program has
ended abnormally, an error message shows.
7. Turn the main switch off and on.
8. Adjust the printer and scanner registration and magnification (
Scanning").
9. Refer to the SMC lists, and enter any values that differ from the factory settings. Double-check the
values for SP 4901.
10. Adjust the standard white level (SP 4428).
11. Initialize the TD sensor (SP 2214).
12. Check the copy quality and the paper path.

Input Check (SP 5803)

- Conducting an Input Check -
1. Select SP 5803.
2. Select the number (see the table below) corresponding to the component.
3. Select "Execute." The copy mode is activated.
4. The sign "01H" or "00H" show (see the table below).
- Input Check Table -
Num. Sensor/Switch
001 Safety SW
002 Safety SW-LD 5V
003 Right Cover SW
004 Right Low Cover SW
005 Tray Cover SW
006 Upper Relay S
007 Lower Relay S
008 Vertical Trans S
009 Registration Sensor
010 Exit Sensor
p.141 "Copy Adjustments Printing/
01H
Open
Open
Open
Open
Open
Paper detected
Paper detected
Paper detected
Paper detected
Paper detected
Using SP Modes
00H
Closed
Closed
Closed
Closed
Closed
Not detected
Not detected
Not detected
Not detected
Not detected
5
155