Use The Extender In Access Point Mode - NETGEAR EX6130 Quick Start Manual

Use the Extender in Access Point Mode

You can use the extender as a WiFi access point, which creates a new WiFi
hotspot by using a wired Ethernet connection.
1. Plug the extender into an electrical outlet and wait for the Power LED
to light green.
If the Power LED does not light, press the Power On/Off button.
2. Use an Ethernet cable to connect the Ethernet port on the extender
to a router Ethernet LAN port or a remote Ethernet LAN jack with LAN
access.
The extender joins the LAN and creates a WiFi hotspot.
3. To make sure that the extender is in access point mode, check to see
if the WPS/Mode LED is off.
4. If the WPS/Mode LED is lit, press the WPS/Mode button for more
than five seconds.
While the extender switches to access point mode, the WPS/Mode
LED and Power LED blink for up to 50 seconds.
Extender
Router
13