Installing/mounting
4.7 Installing option modules
Procedure for installing the EMC filter module
①
②
③
④
Figure 4-19
1. You have performed the steps described in the chapter "General information on installing
option modules (Page 48)".
2. Unplug the ribbon cable connector
electronics
3. Remove the basic electronics
that fix the basic electronics to the pneumatic block.
4. Loosen the screw
5. Then secure the loose ribbon cable (B) on the container as shown in the following
graphic. To do this, use the cable tie (A) supplied with the EMC filter module
C73451-A430-D23
6. Secure the EMC filter module using the screw
7. Fit the basic electronics
8. Insert the ribbon cable connector
electronics.
64
EMC filter module terminals
Positioner
Yellow wheel for locking the position detection
Ribbon cable connector of fitted potentiometer,
or ribbon cable connector of EMC filter module
Installation EMC filter module
⑤
.
⑥
in the connection area of the positioner.
(A)
Cable tie
④
to the fitted potentiometer from the basic
⑤
from the positioner. To this end, remove the two screws
(B)
⑥
⑤
back into the positioner.
④
of the EMC filter module onto the positioner basic
⑤
Basic electronics
⑥
Screw
⑦
EMC filter module C73451-A430-D23
Ribbon cable connector
loosened in the third step.
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11