Siemens SIPART Series Operating Instructions Manual page 63

6. Screw in the special screw
7. Set the limits L1 and L2 as described in the chapter "Setting the limits of the mechanical
8. An insulating cover is provided over the mechanical limit switch module. Place the
9. Place the insulating cover on the mechanical limit switch module by bending the walls of
10.Engage the basic electronics into the four brackets.
11.Fix the basic electronics using both the fixing screws.
12.Reestablish all electrical connections between the basic electronics and the option
13.Using both the screws, fasten the module cover provided. Do not use the standard
14.Select the labels that already exist on the standard version of the module cover from the
15.Establish all electrical connections.
See also
Label set for limit contact module (Page 62)
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
positioner shaft. Tighten the special screw
Note
Pin in the actuating disk bearing
③
A pin is pressed in the actuating disk bearing
③
1. Align the pin before it touches the special screw
2. Rotate the actuating disk bearing
③
the pins fit into the special screw
limit switch module (Page 62)".
insulating cover on one side under the basic electronics seat on the walls of the rack. The
recesses of the insulating cover must fit in the corresponding webs of the container wall.
the rack carefully.
modules. Connect the basic electronics and the option modules to the ribbon cables
provided. Connect the basic electronics and the potentiometer to the potentiometer cable.
module cover.
label set provided. Affix the selected labels on the installed module cover as per the
standard version.
Note
Protective conductor connector
A protective conductor connector is not required for safety reasons and therefore is not
provided.
②
through the mechanical limit switch module into the
②
with a torque of 2 Nm.
①
①
and the special screw
②
.
Installing/mounting
4.7 Installing option modules
.
②
.
②
simultaneously so that
61