Siemens SIPART Series Operating Instructions Manual page 162

Parameterizing/addressing
9.4 Description of parameters
4.INITA - automatic initialization
Use this parameter to start the automatic initialization process. Select the "Strt" parameter
value. Then press the
process from "RUN1" to "RUN5" is output in the bottom line of the display.
The factory setting is "NOINI".
5.INITM - manual initialization
Use this parameter to start the manual initialization process. Select the "Strt" parameter
value. Then press the
Note
If the positioner has already been initialized and if the "INITA" and "INITM" values are set, it
is possible to reset the positioner to the non-initialized status. To do this, press the
for at least 5 seconds.
The factory setting is "NOINI".
See also
Commissioning (Page 113)
Sequence of automatic initialization (Page 117)
Manual initialization of linear actuators (Page 128)
Manual initialization of part-turn actuators (Page 135)
160
button for at least 5 seconds. The sequence of the initialization
button for at least 5 seconds.
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
button