Siemens SIPART Series Operating Instructions Manual page 151

9.3 Overview of parameters
9.3.1 Overview of parameters 1 to 5
Introduction
Parameters 1 to 5 are the same for all versions of positioner. These parameters are used to
adjust the positioner to the actuator. Normally the parameter setup is sufficient to be able to
operate the positioner on an actuator.
If you want to get to know the positioner in detail, gradually try out the effects of the
remaining parameters by systematic testing
Note
Factory-set parameter values are printed in bold in the following table.
Overview
Parameter Function
1.YFCT Type of position actuator
2.YAGL Nominal angle of rotation of the feedback message
3.YWAY Range of stroke (optional setting)
2)
4.INITA Initialization (automatic)
5.INITM Initialization (manual)
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
Parameter values
turn (part-turn actuator)
WAY (linear actuator)
LWAY (linear actuator without sine correction)
ncSt (part-turn actuator with NCS)
-ncSt (part-turn actuator with NCS, inverse
direction of action)
ncSL (linear actuator with NCS)
ncSLL (linear actuator with NCS and lever)
1)
3)
40 | 50 | 60 | 70 | 90 | 110 | 130
Parameterizing/addressing
9.3 Overview of parameters
33°
90°
OFF
5 | 10 | 15 | 20
(Short lever 33°)
25 | 30 | 35
(Short lever 90°)
(Long lever 90°)
NOINI | no / ###.# | Strt
NOINI | no / ###.# | Strt
Unit
Degrees
mm
149