Siemens SIPART Series Operating Instructions Manual page 138

Commissioning
7.5 Commissioning part-turn actuators
4. Call the "INITM" parameter. To do this, press the
following:
5. Start the initialization process. Press the
shows the following:
6. The current potentiometer position is output on the display after 5 seconds:
7. Determine the end position 1 of the actuator.
8. Move the actuator to the desired position using the
9. Press the
following:
Note
Fault message "RANGE"
The selected end position is beyond the permissible measuring range if the "RANGE"
message is output on the display. Correct the settings as follows:
1. Move the friction clutch until the display shows "OK".
2. Press the
3. Move the actuator to another position using the
4. Abort the manual initialization process by pressing the
5. Then return to "P manual mode" mode.
6. Correct the actuator travel and the position detection.
10.Determine the end position 2 of the actuator. Move the actuator to the desired position
using the
136
button. The current position of the actuator is applied. The display shows the
button.
or button.
button twice. The display shows the
button for at least 5 seconds until the display
or button.
or button.
button.
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11