Siemens SIPART Series Operating Instructions Manual page 131

4. Set the "3.YWAY" parameter to determine the total stroke in mm. The setting of the
5. Call the "5.INITM" parameter. To do this, press the
6. Start the initialization process. To do this, press the
7. Determine the end position 1 of the actuator spindle.
8. Move the actuator to the desired position using the
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
"3.YWAY" parameter is optional. The display shows the determined total stroke only at
the end of the initialization phase.
– Briefly press the
in mm. You are then directed to parameter 4.
– Call the "3.YWAY" parameter. To do this, briefly press the
shows the following:
Note
Set the "3.YWAY" parameter
To set the "3.YWAY" parameter proceed as follows:
1. On the scale of the lever, read the value marked by the carrier pin.
2. Set the parameter to the read value with the
the following:
the display shows the following:
The current potentiometer position is output on the display after 5 seconds. Examples of
the displayed potentiometer positions are given below:
button if you do not require any information about the total stroke
7.4 Commissioning linear actuators
button. The display
or button.
button twice. The display shows
button for at least 5 seconds until
or button.
Commissioning
129