Additional Storedge Troubleshooting - SolarEdge StorEdge SE5000-xxS0 series Installation Manual

Additional StorEdge Troubleshooting

Additional StorEdge Troubleshooting
Some of the troubleshooting procedure may require removing the covers of system components
(inverter, battery, StorEdge Connection Unit, or meter). Be sure to disconnect all power sources to avoid
electrocution.
For opening the cover refer to Removing the Inverter Cover on page 34
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the inverter cover is removed.
Problem
During normal operation (grid
supplies power), no power to the
backup loads while the inverter is
producing power
No power to the backup loads
while grid is OFF (power outage)
86
SolarEdge StorEdge -Single Battery/High Capacity Installation MAN-01-00283-1.1
Description or possible cause
The main circuit breakers or loads
circuit breakers in the backed up
loads panel have been triggered
Internal circuit breaker has been
triggered
The inverter is malfunctioning
The backed-up loads are not
backed up
Troubleshooting
Check that the backed-up loads
breakers on the CB panel are in the UP
position
Check that the AC circuit breaker in
the StorEdge Connection Unit is in the
UP position (see Figure 6)
Restart the inverter
If the problem persists, move the
AC bypass switch in the StorEdge
Connection Unit to position 2 (see
Figure 6) to supply power to the loads
until the inverter problem is solved
(contact SolarEdge support if
required). Then move to position 1.
Check that the inverter is
o
producing power
Check that the Backup function is
o
enabled (Backup conf è Backup
è Enable).
Check that there are no errors on
o
the inverter LCD
Check the circuit breakers on the
o
backed-up loads AC panel
Check that the AC breaker in the
o
StorEdge Connection Unit are in
the UP position (see Figure 6)
Check that the AC bypass switch
o
in the StorEdge Connection Unit is
set to position 1 (see Figure 6) .