Inverter Configuration - Setup Mode; Configuring The Inverter Using The Lcd User Buttons - SolarEdge StorEdge SE5000-xxS0 series Installation Manual

Inverter Configuration – Setup Mode
You can configure the inverter using one of the following:
The internal LCD user buttons. When using this option, the inverter cover is removed.
l
The external LCD light button. T his option of configuration includes a less detailed configuration
l
menu.

Configuring the Inverter Using the LCD User Buttons

After inverter installation, a n installer may perform basic system configuration. Configuration is done
when the inverter is in Setup mode.
To enter Setup mode:
1. Turn the inverter ON/OFF switch to OFF (AC remains ON).
WARNING!
If the inverter was operating properly (power was produced by the power optimizers), the
following message is displayed.
This message is displayed until the DC voltage is safe (50V). Do not open the cover until the
voltage is safe or until at least five minutes have passed.
2. Press the Enter button for at least 5 seconds. The following message is displayed:
P l e a s e
P a s s w o r d
* * * * * * * *
3. Use the three rightmost internal LCD user buttons to type in the following password: 12312312. The
following menu is displayed:
C o u n t r y
L a n g u a g e
C o m m u n i c a t i o n
P o w e r
B a c k u p
D i s p l a y
M a i n t e n a n c e
I n f o r m a t i o n
The i nverter is now in Setup mode and all its LEDs are lit. The i nverter automatically exits Setup mode if no
buttons are pressed for more than 2 minutes.
The following shows a hierarchical tree of the menu options, which are described in Configuration Menu
Options on page 48. Actual menus may vary from shown depending on the firmware version of the
inverter and on the country.
SolarEdge-StorEdge -Single Battery/High Capacity Installation MAN-01-00283-1.1
D C
D O
e n t e r
< I t a l y >
< E n g >
C o n t r o l
C o n f < D i s >
V O L T A G E N O T
N O T D I S C O N N E C T
V D C : 7 2 . 0
Chapter 7: User Interface
S A F E
43