Siemens 6DR50 Series Operating Instructions Manual page 69

Procedure for installing the EMC filter module
①
②
③
④
Figure 4-20
1. You have performed the steps described in the section "General information on installing
option modules (Page 48)".
2. Unplug the ribbon cable connector
electronics
3. Remove the basic electronics
that fix the basic electronics to the pneumatic block.
4. Loosen the screw
5. Insert the connector of the ribbon cable (A) into the slot as shown below.
6. Secure the EMC filter module using the screw
7. Fit the basic electronics
8. Insert the ribbon cable connector
electronics.
9. Fasten the module cover. Make sure that the ribbon cable is not trapped.
10.Proceed with the corresponding steps in the section "General information on installing
option modules (Page 48)".
SIPART PS2 with and without HART
Operating Instructions, 09/2014, A5E00074631-12
EMC filter module terminals
Positioner
Yellow wheel for locking the position detection
Ribbon cable connector of fitted potentiometer,
or ribbon cable connector of EMC filter module
Installation EMC filter module
⑤
.
⑥
in the connection area of the positioner.
⑤
⑤
⑥
⑦
④
to the fitted potentiometer from the basic
⑤
from the positioner. To this end, remove the two screws
⑥
loosened in the fourth step.
back into the positioner.
④
of the EMC filter module onto the positioner basic
Installing/mounting
4.7 Installing option modules
Basic electronics
Screw
EMC filter module C73451-A430-D23
67