Siemens 6DR50 Series Operating Instructions Manual page 43

1. Rest the actuator-specific VDI/VDE 3845 mount
Tighten the mount using the hexagon bolts
2. Stick the pointer mark
centering hole.
3. Push the coupling wheel
positioner shaft. Then retract the coupling wheel or the stainless steel coupling by
approximately 1 mm. Tighten the hexagon socket-head screw
wrench provided. Maximum tightening torque = 1 Nm. If you are using the stainless steel
coupling, omit the next step.
Note
Coupling wheel
Instead of the plastic coupling wheel
(article number TGX: 16300-1556).
SIPART PS2 with and without HART
Operating Instructions, 09/2014, A5E00074631-12
⑤
Pointer mark
Coupling wheel
⑦
and lock washers
on the mount. Position the pointer mark at the center of the
Pointer mark, flameproof enclosure
①
or the stainless steel coupling up to the endstop on the
①
, it is possible to use a stainless steel coupling
Coupling wheel, flameproof enclosure
Installing/mounting
4.3 Mounting the part-turn actuator
⑥
on the rear side of the positioner.
⑧
.
⑪
using the machinist's
41