Overview Of Diagnostics Values - Siemens 6DR50 Series Operating Instructions Manual

Alarm, error, and system messages
10.2 Diagnostics
How to show the diagnostics values in reverse order
Press the
How to set values to zero
Specific values can be set to zero by pressing the
diagnostics values which can be reset are listed in the table in section "Overview of
diagnostics values (Page 206)".
10.2.2

Overview of diagnostics values

Explanatory notes on the following table
● The "Representable diagnostics values" column shows the factory settings for the
diagnostics parameters in bold type.
● The "Reset possible" column contains an "X" if the diagnostics value can be set to zero.
● The "Properties" column shows the properties of the diagnostics parameters:
–
–
–
–
Overview of diagnostics values
No. Abbreviation Meaning
1 STRKS Number of total strokes
2 CHDIR Number of changes in direction
3 Number of fault messages
CNT
4 A1CNT Number of alarms 1
5 A2CNT Number of alarms 2
6 HOURS Number of operating hours
7 HOURR Resettable operating hours counter
8 WAY Determined actuator travel
9 TUP Travel time UP
10 TDOWN Travel time DOWN
206
and buttons simultaneously.
①
Diagnostics value can be read and reset.
②
Diagnostics value can be read but not reset.
③
Diagnostics value can be read but not reset. A function can be executed.
④
Diagnostics value can be read, manually reset, and manually changed.
button for at least 5 seconds. The
Representable Unit
diagnostics val-
ues
0 ... 4.29E9 -
0 ... 4.29E9 -
0 ... 4.29E9 -
0 ... 4.29E9 -
0 ... 4.29E9 -
0 ... 4.29E9 Hours
0 ... 4.29E9
0 ... 130 mm or °
0.0 / 0 ... 1000 s
0.0 / 0 ... 1000 s
SIPART PS2 with and without HART
Operating Instructions, 09/2014, A5E00074631-12
Properties
①
①
①
①
①
②
①
②
②
②