Table of Contents
Advertisement
Removing or replacing the service door
Removing the service door
Remove the service door to access the hard drive and other components.
1.
Remove the battery (see
2.
With the battery bay away from you, remove the screw (1), tilt the service door up (2), and then
lift the service door away (3).
Replacing the service door
Replace the service door after accessing the memory module slot, hard drive, regulatory label, and
other components.
1.
With the battery bay away from you, tilt down the service door to align the front edge of the
service door near the front edge of the computer (1).
2.
Insert the alignment tabs (2) on the rear edge of the service door with the notches on the
computer, and tilt down and into place.
Inserting or removing the battery on page
34).
Using hard drives
43
Advertisement
Table of Contents
