CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Use of Torque Wrenches and Adaptors
8.4
All final torquing shall be carried out with certified torque wrenches or torque screwdrivers.
When adaptors or extensions are used on manually operated torque wrenches, they shall be
aligned as shown in Figure 5.2.2 and the dial reading required shall be calculated from the
following formula:
Dial Reading = Specified Torque x L
L+L
1
Figure 5.2.2: Use of Torque Wrenches
Dimensions must be measured in the same units (i.e. both in inches, both in feet, etc.) for each
calculation. Different units must not be mixed.
5.2
Manual number SC10000AMM
Date: 10/01/2010
Page: 11