Cub Crafters CC11-100 Maintenance Manual page 38

CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
When nuts are to be secured to fasteners by means of cotter pins or lock wire, the low side of
the specified torque range shall be approached for tightening. If necessary, tightening shall be
continued until the next slot aligns with the hole.
Nuts shall not be loosened to obtain the required alignment.
The maximum torque shall not be exceeded.
Threaded fasteners which have been torqued above the maximum value specified shall not be
backed off and re-torqued but shall be removed, rejected and rendered unserviceable.
If there is any doubt a fastener has been under-torqued, the nut shall be backed off one
complete rotation (360°) maximum and retightened to the specified value; the bolt, screw or stud
must not be allowed to rotate.
5.2
Manual number SC10000AMM
Page: 10 Date: 10/01/2010