Cub Crafters CC11-100 Maintenance Manual page 328

Operational/Functional Inspection Report
7 Battery Master Switch:
- Switch on
- Verify voltage
- Flag on turn coordinator should disappear.
8 Start engine using procedure in Pilot's Operating Handbook,
Section 4.
9 Set 1700 RPM:
- Perform magneto check
- Drop not to exceed 150 RPM or 75 RPM differential
between magnetos
- No engine roughness.
10 Pull Carburetor Heat Knob:
- Engine RPM should show a slight drop.
11 Apply a Load to the Electrical System (e.g. switch on landing
lights):
- Observe that voltage remains constant and amperage
increases when load is applied (if ammeter installed).
13 Check the radio for proper Nav and Com operation.
14 Check the transponder for proper operation.
15 Verify proper ELT operation.
16 Set throttle to idle:
- Engine should idle between 500 and 750 RPM.
17 Set 1000 RPM.
18 Turn engine off by slowly pulling mixture control.
An increase in RPM prior to the control reaching idle cut-off
position indicates proper air fuel mixture.
6.A
Page: A10
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
NOTE
Initials Notes
Manual number SC10000AMM
Date: 01/31/2011